Woodworking is a craft like no other. You get to work with one of nature’s most useful resources and make something with your mind and hands. Whether you do this personally as a hobby, professionally for money or are just reading about it as a future possibility, this article has tips you can use to be a better woodcrafter.
Woodworking can be a fun, and satisfying, hobby. However, it is very important to play it safe when working with tools, substances that cause fumes and other common dangers of the craft. Be sure to wear safety glasses, allow plenty of fresh air for ventilation when using oil-based products and always read the directions before you start anything!
You can use stair gauges to make crosscut guides. With a carpenter’s square these can be clamped down to match up the stair jack. Be sure to mark the location of the notches. If you put them on the same tongue of your carpenter’s square, the combination that you can make will be a great circular saw crosscut guide.
Stir stains and finishes instead of shaking them to mix. Some ingredients in these products may settle over time. But, if you shake it could cause bubbles to form which would mean it wouldn’t mix too well. Stir as best as you can to prevent this from happening.
Use hot glue instead of clamps for little things. When cutting, filing, sanding, or finishing something small, use the hot glue gun to glue the piece to your pedestal stick. The glue holds holds just like clamps, if not better than clamps. It also works great for things that clamps will not work on. When you finish your project, loosen it gently with a putty knife.
A stair gauge is a great tool to keep in your shop. These are usually used for laying out stair jacks; however, you can also use it to clamp down your carpenter’s square. This can make a carpenter’s square serve as a guide for a circular saw. Using this square will allow you to make cuts that are straight.
Sometimes a little bit of glue is better than a clamp. Every woodworking shop should have a hot glue gun. Hot glue will hold small pieces better than any clamp ever could, if you could even maneuver one in place. When you are done, just gently pry loose with a putty knife.
If woodworking is new to you, one of the most important pieces of advice to take is to thoroughly read all plans and instructions before you begin anything. You should fully understand everything that you will need to do. If you find the plans hard to understand, ask someone with more experience. If they are professional plans, ask the place that sold them to you.
The craft of woodworking is unlike most others. It is a medium where humans take a strong natural resource and work in ways that leaves anything from pieces of art to buildings. Whatever your personal level of involvement in woodworking is, this article had tips and tricks in it you can surely use.…